ZCar Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
340 Posts
Discussion Starter · #1 ·
I have had my Z in storage for about a year. It was running fine when it was parked, but now it has a problem. I won't rev over 3500 rpm and it chokes and died if you give it to much gas. I pinched off the gas line to restrict the fuel flow and it runs smooth.
I have checked the cold start valve, and there are is nothing blocking air flow to the engine.
Does anyone know what would cause this???
 

·
Registered
Joined
·
340 Posts
Discussion Starter · #5 ·
Well, I went out and worked on my car today. I cleaned that bullet connector for the temp. sensor, and that didn't do it. Then i started to pull off fuel injector connectors.
When I took off the #1 injector connector the car started to run better. I can even leave the connector off and it work better.
So, i think that the #1 injector is stuck open.
Any other ideas????
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top