ZCar Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
1,047 Posts
Discussion Starter #1
i would like to do a 4 to a 5 lug conversion. i would either like to run corvette wheels, or 90-96 300zx wheels. i already bought 90-96 wheels. can i use the rear spindles aka shafts in a 77 280z? or is the some type of conversion plate i can mount up? or how do it do it? i have seen it done so i know i can do it but i don't know how.
 

·
Registered
Joined
·
241 Posts
I'd check the archives here and on hybridz.org, I'm sure alot of people have talked about this, especially at hybridz. What do those rims of yours look like? any pics? I've seen 84 300 rims on these cars, but hav'nt seen anything newer from nissan.

Dylan
 

·
Registered
Joined
·
241 Posts
I'm sure I seen an article on this online as well... I forget where, but it is out there. You should check around the z cites for info under articles.

Dylan
 

·
Registered
Joined
·
1,047 Posts
Discussion Starter #4
just check ebay they always have 90-96 300zx wheels there.
twin turbo wheels are a bit wider they are like 16X 8.5 wide.
would u happin to know if there is a infomation site for 70-78 z's
like there is for 300zx's
i know for 300zx there is z31.com and z32.com
 

·
Registered
Joined
·
5,597 Posts
I have the whole Dana 36 IRS from a vette under my 77. Comes with 11.5" vented rotors and 5 lug chevy style BTW. I'm changing out the front hubs to 300ZX 5 Lug Hubs also. You can see one being installed over at hybridz.org by SCOTTGNz.

Z U V8ter
 

·
Registered
Joined
·
91 Posts
5 lug Z32 rims and pics

i did this a few years ago.
pics online of my convertible with the 5 lug conversion and 91 300 rims some pics prior to polishing and more after..

its not that hard to do but youwill need coilovers and spacers on the rear

pics at

www.fonebooth.com/auto.html

look in the convertible 5L section
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top