ZCar Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
107,695 Posts
Skinny Screwdriver

> how do you install the rubber door stops?

I put new ones in my 78 Z using just a small flat-tip screwdriver. I wet one of the nipples by putting a little saliva on it (maybe gross, but free and available...), then used the screwdriver to gently push the nipple in till it seated fully. Then I bent the doorstop out a bit and slowly worked the screwdriver around, pushing the other nipple in bit by bit till it seated. They both stayed in.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top