ZCar Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Thank you everyone for your help.
so far so good.
I have an 85 non turbo. had the problem with the engine going to 2200 to 0 to 2200 (up and down). replaced all the basics, still same problem.
Pulled the air flow meter, turned the adjusting screw back and forth a couple times and so far problem fixed.
Screw is plugged on the top of the unit so it has to be drilled out, carefully though, screw is plastic.
I did also notice when the car is at idle and i pulled the harness enigine would die and not restart until i reconnected it. now at idle if unplugged car stays running and will start.
So like i said before so far so good, but we'll see what happens.
Once again thank you everyone here for your posts, and help. couldn't have done it without ya,
ZYALATE,
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top