ZCar Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
107,695 Posts
Discussion Starter #1
I just baught a set of seats from a 1st gen 300zx, They are in good shape and I am gonna have them recovored to my original colors.I like these seats cause they have power lumbar and a heck of a good adjustable boalster.My question is will the stock seat rails bolt on these seats and how hard is it to wire up power seats to a non power seat car.Thanks for any info guys. LaterZ
 

·
Registered
Joined
·
824 Posts
Re: sorry going in 83 280zx n/c

Nope the 280ZX brackets mount to the bottom of the seat and 1 of the 300ZX mounts to the side of the seat. You could possibly drill and tap new holes in the 300ZX seats that would mount to the 280ZX brackets but I think you would have level problems. Also the 300ZX seats are wider.
 

·
Registered
Joined
·
107,695 Posts
Discussion Starter #4
Well Darn!

Well I am gonna try and make it work.. I just like the 300zx seats. I hope to make it work...Thanks for the info zbyter..
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top