ZCar Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

· Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
I am finally getting my 1977 rear-end back together (poly bushings project) and am getting ready to put the driveshaft back in.

Do I need to apply some grease to the end of the driveshaft going into the tranny? If so, what type of grease?

P.S. 280zone....if you are out there...I want to buy those rims this week!!

Thankz...

Ron

1977 280Z
1978 280Z
1974 260Z R.I.P.
 

· Registered
Joined
·
4,552 Posts
Ron, any light coating of grease should work. Give me a day or so notice and I will get the rims out of the garage.
 

· Registered
Joined
·
3,207 Posts
Hi Rpugh.
No. You will not need any grease... that is a waste. Just be certain to top off the tranny fluid you leaked when removing your driveshaft. Have fun. shane-
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top