ZCar Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Don't ask, something stupid, cam shaft gear bolt vibrated/backed out, not all the way, so the cam gear was spinning, and the cam was not, and you all know what happened next.

I need to know what potentially needs to be replaced beyond:
1. I know I need all new valves, some are bent not all of them, going to replace all of them.
2. All new valve seats
3. New valve guides? Do I need to replace the valve guides?
4. 4 of the pistons have very minor dents. I think I can smooth them out using 220 grit sand paper, so I don't have hot spots, does this sound ok?
5. How about anything else? Any thing in the bottom end that potentially could have gotten bent?

Thanks for the help/Info ahead of time,

Terry
 

·
Registered
Joined
·
89 Posts
If your that far into it yo may as well go through the bottom end while your at it.
No one on here can tell you if you did more damage than the obvious unless you pull it apart and look at it.
 
1 - 2 of 2 Posts
Top