ZCar Forum banner
1973
1-5 of 5 Results
  1. 70-83 Tech Discussion Forum
    Hello, I have a 1973 240Z and recently ran into an issue I can’t quite figure out. I can crank the car and it will start up beautifully but even with full choke the car slowly drops in rpm until it eventually dies. Giving it gas will prevent it from dying but it cannot idle on it’s own. Does...
  2. 70-83 Tech Discussion Forum
    I am replacing the flat tops on my 1973 240Z with round tops off of a 1972. I have the carbs mounted up, and I find that the ‘73 throttle linkage that extends from the fire wall to the carb set up is about 2 inches too short to reach. I’m currently looking to buy a ‘72 throttle linkage, and I’ve...
  3. WTB: Parts & Accessories
    Hi Everyone, I’m looking to buy the piece of the ‘72 throttle linkage that extends from the fire wall to the round top carb set up. I am replacing the flat tops on my ‘73 with round tops off of a ‘72, and the ‘73 throttle linkage is about 2 inches too short. You can contact me at...
  4. 70-83 Tech Discussion Forum
    Hey all! During I have a last production month 240z that I am currently restoring. Here are the pictures of the thermostat housing. As you can see there is some kind of sensor at the top of it. Does anyone know what sensor it is? One of the wires broke off, so I need to replace it. When I...
  5. 70-83 Tech Discussion Forum
    Could somebody please tell me what these are, what they are for, and where they go? Thank you so much. They’re off my 1973 240Z. Has ‘72 parts as well if that helps. Thanks.
1-5 of 5 Results
Top