How to run Airbag codes FAQ - Nissan : Datsun ZCar forum :Nissan Z Forum: 240Z to 370Z
User Tag List

 
LinkBack Thread Tools
post #1 of 1 (permalink) Old 01-04-2005, 03:50 PM Thread Starter
Senior Member
 
Join Date: Sep 2002
Posts: 8,557
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Quoted: 0 Post(s)
(Thread Starter)
How to run Airbag codes FAQ

Because both the search results and the FSM instructions on how to do this aren’t exactly clear, here’s something that I hope is easier to understand.

If your airbag light flashes after 7 secs, then you need to run the airbag diagnostic codes, if your airbag light does not shut off after 7 secs then the airbag ECM needs to be replaced. To run the codes you must enter the first diagnostic mode, from there you can read the number of light flashed to see what the problem is. The second diagnostic mode is meant to show what codes have been cleared, and is not useful for diagnosing problem.

There are 3 modes for the airbag ECM diagnostic unit:
User (Normal)
Present (Diagnostic Mode 1)
Initial (Diagnostic Mode 2)


User (Normal):
This is the mode your car is in when it is not in diagnostic mode, it needs to be left in this mode for proper use of the SRS system, be sure to return the ECM to this mode after completing diagnostics.
Present (Diagnostic Mode 1):
This mode will display the codes causing the error in the SRS system, the number of short flashes of the airbag light corresponds to the error code.
Initial (Diagnostic Mode 2):
This mode is only useful to see what codes have been cleared, it will also show what code is causing the problem.

Most people, if ever, will only need to enter mode 1, follow the instructions below, simply ignoring the mode 2 instructions.

To enter Diagnostic Mode 1 you will need to activate the drivers side door switch(located in the door jamb near the latch striker) at least 5 times within 7 seconds after the ignition is turn to on.

To enter Diagnostic Mode 2 you will need to turn the key off then back to on, then activate the drivers side door switch once AFTER the ignition has been turned on for 7 secs.

To exit Diagnostic Mode 2 you will need to turn the key off then back to on, then activate the drivers side door switch once AFTER the ignition has been turned on for 7 secs.

To exit Diagnostic Mode 1 you will need to turn the key off then back to on, then activate the drivers side door switch(located in the door jamb near the latch striker) at least 5 times within 7 seconds after the ignition is turn to on.

Now for a visualadaptation from the FSM)


Before switching between the modes shown above remember to turn the key off then on, otherwise the system cannot accept the door switch inputs.

After switching to mode 1 the "Airbag" light will flash once long, indicating the code series is about to start, the following number of short flashes is the number of the code causing the error in the SRS system. If the airbag light flashes on for 2 secs and off for 3 secs then that indicates no problem, or an intermittent problem.

1- Safing Sensor circuit is out of order.
2- Driver's air bag module circuit is out of order.
3- Tunnel sensor circuit is out of order.
4- Right crash zone sensor circuit is out of order.
5- Left crash zone sensor circuit is out of order.
6- Center crash zone sensor circuit is out of order.
7- Diagnosis unit is out of order.
8- Front Passenger air bag module circuit is out of order.
9- More than 2 parts of the SRS system are out of order.

Chances are if you have a code that its something simple, the most common thing is the spiral cable in the steering column. I had the center and left crash sensors plugged in incorrectly(switched) and I got a code 6.
zluster is offline  
Sponsored Links
Advertisement
 
Closed Thread

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Nissan : Datsun ZCar forum :Nissan Z Forum: 240Z to 370Z forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



  Similar Threads
Thread Thread Starter Forum Replies Last Post
does my 90' 300zx have and airbag encore36 90-96 Tech Discussion Forum 24 10-10-2007 06:44 PM
airbag light harrieyu 350Z Tech Discussion Forum 5 04-04-2005 09:03 AM
Another article to contribute to a tech page: Running airbag codes zluster 90-96 Tech Discussion Forum 13 08-02-2004 02:42 PM
airbag?? 90charcolez 90-96 Tech Discussion Forum 4 02-28-2003 10:08 AM
anyone ever need an Airbag ? cypressdowns 90-96 Tech Discussion Forum 2 03-18-2002 07:49 PM

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome
 


Content Relevant URLs by vBSEO 3.6.1