Figure I need to drop the exhaust. All of it or just cat back. My stupid cat back now being a one piece is a PITA to remove.

Guess not.

[twinturbo.net]



Edited 1 time(s). Last edit was 2008:08:20:00:12:56.

I did mine with only the catback removed.

---

If I had a Z, it'd be silver... no... BLACK...

1991 Black 300ZXTT 2+2

Ruler of the Coastal Empire

You only need to remove the CAT back but if yours is welded to the CATs, then you'll need to drop the whole thing.

---

*-- Just some stuffy advice from an old fart who's too set in his ways. --*

You might want to consider "balancing" the drive shaft before you install it. When I got my Z1 ds, I had it balanced just to make sure all was well. Sure enough it was off a couple oz's. Just a thought.

I still have the flange at the cat. Jsut not the one at the rear most section.

I found that the rock I ran over peirced a hole in my back muffler. Right next to the gas tank. CRAZY!

I installed my Z1 drive shaft with out removing the exhaust,because I stripped all the exhaust bolts.

I just popped the rubber hangers off the piping and slid it in.

BTW I have the stillen exhaust, maybe that made more room to work with.

---

1990 N/A slightly modified

Zcar

If you are a rush for that OEM DS. I found one on ebay.

[cgi.ebay.com]

Thanks MrPulldown.

There is a member here who emailed me about his OEM DS that he has available. I just haven't written back with an offer. I'm going to soon.

---

If I had a Z, it'd be silver... no... BLACK...

1991 Black 300ZXTT 2+2

Ruler of the Coastal Empire

you gonna measure that shaft too Mr. Wolfgang Güllich

---

Veritas Aequitas


Chrome TT wheels 500.00 plus shipping

Move to PDX??? cancelled.

I have an oem ds. Came out of a 95na with 90k. Nothing wrong with it, just wanted a 1 piece. mjziggy2@msn.com

Man so close. Dropped the giant exhaust system. Almost got the new DS in Place. The splines are a @#$%& to line up and after going in half way the back end is caught up on the rear sway, and making too extream an angle for the yoke to slip in. Need to pull the rear sway, and try again.