Apologies if this is reposted. Was unable to confirm its posting last night...
So I replaced inner and outer tie rods with new from black dragon(along with other goodies). They come with grease zerks. Outer accepts grease with no issues. Inner however will not take any. I took zero off and it works fine. With gun attached, grease flows. Took outer zerk off and stuck a clean pin in....it goes in 1/4 inch or so. Took inner zerk off and it appears not to have a hole in it. The fitting must just hit inner metal. What's the deal or more importantly the fix to fill with grease? Does one have to drill a hole? Also can you over fill boots? Grease is spooing out the others? Thanks
So I replaced inner and outer tie rods with new from black dragon(along with other goodies). They come with grease zerks. Outer accepts grease with no issues. Inner however will not take any. I took zero off and it works fine. With gun attached, grease flows. Took outer zerk off and stuck a clean pin in....it goes in 1/4 inch or so. Took inner zerk off and it appears not to have a hole in it. The fitting must just hit inner metal. What's the deal or more importantly the fix to fill with grease? Does one have to drill a hole? Also can you over fill boots? Grease is spooing out the others? Thanks